ii
Q.
The GFCI is tripping frequently. What I can I do?
A.
if the GFCi is tripping frequently, there could be several problems.
water is getting inside the polisher. Dry the tool with compressed
air and try to prevent water from getting into the polisher.The
voltage drops due to sharing the same power source in a work area.
Too much force is applied to the tool. Back-off on the pressure.
The outlet may be loose. Make sure the power cord plug is tightly
inserted in the power outlet. Contact Alpha Professional Tools® tool
repair department for further advice.
Q.
If my VSP-120 breaks down, whom should I contact for repair?
A.
Contact the dealer where you purchased the tool or Alpha
Professional Tools
®
directly at 800-648-7229.
Q.
Can I use my VSP-120 as a wet cutting tool with a diamond blade?
A.
No. The VSP-120 only has a 2,800 no load rPM rating. This is not
enough rPM for cutting applications with a diamond blade. it is
unsafe to use the VSP-120 as a cutting tool. Do not attempt to cut
with the VSP-120.
Q.
Can I use my VSP-120 for dry polishing applications?
A.
No. The VSP-120 is designed for wet use only. Alpha® recommends
using our AwP-158/214 for dry polishing applications.
Q.
How can I get the parts list and schematic for the VSP-120?
A.
There are several ways to obtain information such as this from Alpha
Professional Tools
®
. it is available on our website www.alpha-tools.
com or by contacting our Tool Dept Help Desk at 800-648-7229.
Q.
What is the proper RPM for polishing Engineered Stone?
A.
Any rPM range on this polisher will work for polishing engineered
stone. Using slower rPM together with the Alpha® Ceramica EX will
provide the optimum polish on engineered stone material.
Q.
What is the largest diameter accessory that the VSP-120 will accept?
A.
The VSP-120 will accept accessories up to 5”. Do not attempt to
use accessories larger than 5” for safety reasons. in addition,
large accessories require more torque than the VSP-120 can
provide. Operating the VSP-120 under these conditions will result in
overheating failure.
Summary of Contents for VSP-120
Page 27: ...25 ALPHA VSP 120 SCHEMATIC ...
