Alpha IP RTA 61001-N, Quick Install Manual

Page: 17 / 116

17
Operation
ENG
NOR
SWE
DA
N
FIN
POL
RU
S
ENG ENG
5.2.3 Installation with adhesive strips
Depending on the ground, installation can be performed using the supplied dou-
ble-sided adhesive tapes. Installation is possible on different grounds, as e. g. ma-
sonry, furniture, tiles or glass.
1. Select an appropriate installation position.
If the installation is done with adhesive strips, the installation surface must
be smooth, level, undamaged, clean, and free from grease and solvents.
2. Remove the protective foil from one side of the adhesive strip.
3. Fix the adhesive strip on the back side of the installation bottom in the recesses
provided for this (see fig. 4c page 4).
4. Remove the protective foil from the other side of the adhesive strip.
5. Align the device horizontally to the desired position and press it on.
6 Operation
The target temperature is set manually on a scale from 0 to 5 by turning the setting
wheel (E) to the left or to the right.
6.1 Set value balance (offset)
Since the temperature is measured at the room control unit, it may be warmer or
cooler in another position in the room. The deviation can be corrected via a set