15
Subject to technical amendments without prior notice | 83070000cUK | ait-deutschland GmbH
8.2.2 Jersey 7
PWB1 Control board
PWB3 EMC filter board for inverter
PWB2 Inverter
TB
Connection terminal for power supply and
communication with communication board
AA23
AA23-X100
Communication with TB on control
board
AA23
Communication board
AA23-S3
DIP switch for addressing the heat
pump
AA23-X4
Connection terminal for communi-
cation cable from the hydraulic unit
AA23-F3
Fuse for external heating cable
(250 mA), max. 45 W
AA23-X1
Connection terminal for heating
cable of the condensation water
pipe KWS (accessories)
8.3 Making electrical connections
1. Extend the pre-installed power cable of the heat
pump (W1, approx. length 1.8 m) with a 3-core pow-
er cable (3G 2.5 mm²)
Alternatively: Uninstall the pre-installed power ca-
ble of the heat pump and replace it with a 3-core
power cable (3G 2.5 mm²) of the required length.
Strip the sheathing off the new power cable and
wrap it around the ferrite core in the same man-
ner as the original cable was wrapped around the
ferrite core.
2. Route the power cable into the building to the hy-
draulic tower HT 7.
3. Route the communication cable (W2) through the
cable bushing (UB2) from outside into the heat
pump.
Jersey 5
Jersey 7
4. Only for Jersey 7:
Route the communication cable (W2) in the heat
pump through the ferrite ring (
①
) on the commu-
nication board.
Jersey 7
5. Strip the communication cable (W2). Stripping
length of the individual wires: 6 mm each.
6. Route the communication cable (W2) to the con-
nection terminal AA23-X4 on the communication
board.
