5
We reserve the right to modify technical specifications without prior notice.
83053600bUK – Translation of the operating manual
© Alpha-InnoTec GmbH
customer service
for technical information please contact a qualified
technician or the manufacturer’s local partner.
operating instructions for your heat pump,
Appendix, customer service, addresses for
service
Warranty / Guarantee
for warranty and guarantee conditions, please refer to
the purchase documents.
note.
please contact your dealer concerning warran-
ties and guarantees.
Disposal
When decommissioning the unit, always comply with
applicable laws, directives and standards for the recovery,
recycling and disposal of materials and components.
“dismantling”.
Operation
your decision to purchase a heat pump or a heat
pump system is a long-term contribution to protecting
the environment through low emissions and reduced
primary energy use.
you can operate and control the heat pump system
with the control element of the heating and heat pump
regulator.
note.
make sure that the control settings are correct.
operating manual of the heating and heat pump
regulator.
To ensure that your heat pump or heat pump system
operates efficiently and ecologically, the following are
especially important:
€
energy savIng tIp
Avoid unnecessarily high flow temperatures.
A lower flow temperature on the hot water side
increases the efficiency of the system.
€
energy savIng tIp
preferably use rapid ventilation. To save energy
and reduce your heating costs, do not leave win-
dows open for long periods.
care of the unit
The outer surfaces of the unit can be cleaned with a
damp cloth and household cleaning products.
do not use cleaning or care products that contain
abrasives, acids and/or chlorine. Such products would
destroy the surfaces and could also damage the technical
components of the unit.
Heat metering
In addition to proof of the unit’s efficiency, the
EEWaermeG also requires heat metering (hereafter
referred to as HqR). Heat metering is mandatory for
air/water heat pumps. Heat metering for brine/water
and water/water heat pumps only have to be installed
for a flow temperature ≥ 35 °c. The heat metering must
record the total thermal energy released (heating and
domestic hot water) in the building. In heat pumps with
heat metering, the analysis is carried out by the regulator.
The regulator displays the thermal energy discharged in
the heating system in kWh.
note.
Unit variants are available, with or without heat
metering.
Summary of Contents for HMD 1
Page 32: ......
