I N S T
I N S T
A L L A
A L L A
T I O N
T I O N
CHOICE OF THE INSTALLATION LOCATION
• Let a 50 cm space all around the unit.
• After unpacking, place the unit upright to allow
the cooling agent to stabilize and wait 3 hours
before use.
AIR EXHAUST DUCT MOUNTING METHOD
Fig. 5
1. Temporary method
• Fix the end of the exhaust duct to the exhaust terminal of the unit.
• Half-open the window and let the air outlet duct get through.
2. Permanent method
• Fix the end of the exhaust duct to the exhaust terminal of the unit.
• Dig a hole (> 136 mm) on the wall.
• Fit the supplied round window connector on the air outlet duct then let it get through the wall.
BE CAREFUL : the length of the exhaust pipe is between 390 mm and 1500 mm. Use the shortest possible
length. When mounting, we advise to keep the exhaust pipe in a horizontal position.
When the hole is not in use, use the cap to cover the hole.
GOOD MOUNTING
• If the exhaust pipe has to be bended it should be proceeded
as shown on : Fig. 7
WRONG MOUNTING
• The bend of the exhaust pipe is too important and
can occur a wrong working of the unit. : Fig. 8
WARNING
• The length of the exhaust pipe is specially designed according to
the specification of this product. Do not replace or prolong with
your own private hose as this could cause the unit to mal-function.
15
notice AC105.1ETP 5/12/06 17:36 Page 15
