W
W
A
A
T E R D R A I N A G E M E T H O D S
T E R D R A I N A G E M E T H O D S
• During the cooling process, water is extracted from the air into the unit. When the water tray of the unit is
full, the compressor stops, the fan only continues to run.
• Empty the water tray : the cooling process will run again.
A. WATER DRAINAGE WITH WATER TRAY
Fig 21
1. Switch off the appliance
2. Place the water tray on the floor under the drain hole.
3. Take off the water stopper and the rubber plug of the drain hole, the
condensed water will go automatically into the tray.
4. When the water tray is almost full replace the rubber plug of the
drain hole and the water stopper. Empty the water tray.
5. Do the operations 2 – 3 – 4 again until there is no more water in unit.
6. Place then the rubber plug firmly into the drain hole. The full tank
indicator should be switched off.
B PERMANENT DRAINAGE
Fig. 22 and 23
1. Take off the water stopper and the rubber plug (fig. 22). Keep
them aside.
2. Connect the adapted pipe to the drain hole, the condensed
water will go automatically (fig. 23).
3. You can add an extension to the water tube (diameter 18 mm)
(fig. 24).
20
Adapted pipe
Extension
Rubber
plug
Water
stopper
Rubber
plug
Drain hole
Water tray
Rubber plug
Water stopper
notice AC105.1ETP 5/12/06 17:36 Page 20
