Almex T4PGF1, Instruction Manual

Page: 18 / 30

T4PGF1 INSTRUCTION MANUAL Page 18
SHAW-ALMEX INDUSTRIES LIMITED June 14 2017
EQUIPMENT/ASSEMBLY Prior
to
each
use Every
month
or 30
Cycles Every
6 th
month
or
180
cycles Every
Year
Please
initial if
the items
passed
inspection
COMMENTS
Check All Earth Resistance values by Checking
Resistance Continuity from The Main Incoming
Earth To the Receptacle Earths. All
Earths/Grounds
MUST
be below 0.5 Ohms.
X X X X
Check E-Stop operation.
X X X X
Open case and check for loose or damaged
parts X X
Inspect ALL wires and terminations and
terminals for tightness, (
contact Almex for
instructions or have The technician check
during inspection)
.
X X
Run a complete cycle to check the operation of
the unit under normal electrical work loads and
conditions,
(Contact Almex for instructions).
X X
Check for proper temperature controller
readings (
Contact Almex for instructions or
have The Technician check during inspection
).
X X
Check for proper resistance settings on the
pilot checking circuits. Yellow light must
indicate below 350 ohms. Red must be
indicating above 440 ohms.
Contact Shaw
almex for proper testing.
X X
Use a Mega Ohm tester to test L1 to L2, L2 to
L3, L3 to L1, and all lines to Earth. The test
Must show a resistance higher than 1 Meg.
X
Name of person performing inspection:
Date of Inspection:
Time Inspection Completed:
Signed by person performing inspection:
Serial number of equipment inspected:
If any component is found to be unserviceable, tag the component out of service and notify the Supervisor in charge immediately. Replace
with ONLY Exact Replacement Parts. check with Shaw Almex for Exact Part Numbers if there is any Doubt At All.