STM – Initial Setup
5
User Manual v1.0
www.shield.com
The device all provides the command line interface accessible via SSH, which will allow to
configure the basic settings and view device status.
Management Access
Login Credentials
WebUI
admin/admin
SSH CLI
admin/stmadmin
2.3. Accessing the WebUI
To access the device WebUI,
1. Connect the serial console the serial port of STM device.
2. Use the following serial console settings to access the Shield CLI
i. Speed : 38400
ii. Parity : None
iii. Data : 8
iv. Stopbits : 1
v. Flowcontrol
:
No
3. From the Shield command prompt, execute the following command to view the IP
Address acquired by the device.
shield>show ip
Now you can access the device from the browser using the URL as given below
https://<device-ip
>
Note:
The WebUI has been made accessible only via HTTPS. The Device WebUI Server has been
made to use Self signed PKI Certificate, Thus the browser will prompt to accept the self
signed certificate generated by the device on accessing the WebUI.
The recommended browser for accessing STM WebUI is Mozilla Firefox.
Note:
If you are not running the dhcp server in your deployment OR device fails to acquire the ip
address, set the ip address from the console CLI using the command line
shield>set ip <ipaddress> <mask> <gateway>
Summary of Contents for Shield STM
Page 1: ......
Page 2: ...User Manual Shield STM Appliance 1 0 Version 1 0 ...