![background image](http://html1.mh-extra.com/html/allo-com/2acp8e-series/2acp8e-series_quick-installation-manual_2903744016.webp)
8 Port PRI Card- Quick Installation Guide
www.allo.com
Version 2.1 16
5. Software Configurations
Add the line
“allo4xxp”
at the end in /etc/Dahdi/modules file. The “start dahdi” is to “stop and
start dahdi service” according to deployment scenario.
After compiling and installing DAHDI and Asterisk, load the Dahdi driver by running:
#
/etc/init.d/dahdi start
#
dahdi_genconf –vvvvv
If there is any error, please trace the cause. Until all errors are clear up, you should
execute "dahdi_genconf" again, and then go to the next step.
By running
"dahdi_genconf"
, it will generate /etc/dahdi/system.conf and etc/asterisk/dahdi-
channels.conf automatically. Check whether the generated files information agrees with your
hardware setup, if not, you should modify to your specific requirements.
Dahdi Channels Configure With asterisk
Do not forget to confirm dahdi-channels.conf is included in chan_dahdi.conf to
configure Dahdi channels with asterisk, if not, run command:
# echo "#include dahdi-channels.conf" >> /etc/asterisk/chan_dahdi.conf
Execute the following command:
# dahdi_cfg –vvvvv
This command is used for reading and loading parameters in the configuration file system.conf
and writing to the hardware.
Start the Asterisk by executing