31
B
A
Booster Cables
To use booster cables:
1. Connect one end of red positive (+) cable (
C
) to
positive (+) terminal of machine battery (
D
).
2. Connect other end of red positive (+) cable to
positive (+) terminal of external battery (
E
).
3. Connect one end of black negative (–) cable (
F
) to
negative (–) terminal of external battery.
4. Connect other end of black negative (–) cable to
engine block of machine (
G
, not shown).
CAUTION
Be careful not to connect positive (+) and negative
(–) terminals backwards.
5. Start engine.
6. Disconnect booster cables by following above
procedure in reverse order.
E
F
G
D
C
Check Thermal Relay
1. Turn the starter switch to the ON position.
2. Set the main circuit breaker to the ON position.
3. The three phase main breaker will trip if you push
the test lever (
H
) of the thermal relay.
4. Note that once the three phase main breaker trips
to the off position, the single phase breaker that
supplies power to the GFCI outlets can still be ON.
H
Change Fuel Filter / Pre-Filter Element
(For element part numbers, see
Replacement Parts
)
1. Remove the old filter.
2. Before installing the new filter (
I
), spread a thin layer
of oil over the seal (
J
), then install. When the seal
touches the sealing surface, further tighten the filter
by approximately two-thirds turn with a filter wrench.
3. After the filter is installed, check for any oil leaks
during operation.
J
I
Go to
Discount-Equipment.com
to
order your parts
Summary of Contents for Maxi-Power MP65-8C1
