Allmand Maxi-Power MP65-8C1, Operator'S Manual

Page: 29 / 55

28 ALLMAND.COM
Replacement Parts
Note: Part numbers may change without notice.
Contact your authorized dealer.
Part Name Part Number Qty
Air Filter Element 32143 11800 1
Engine Oil Filter Kubota HH1C0-32433 1
Fuel Filter Element Kubota 1K947-43171 1
Fuel Pre-Filter Element Kubota HH166-43561 1
Belt Kubota 1G381-97010 1
Breather Filter Element (with O-Ring) Kubota 1J419-05481-0 1
Maintenance Items
Change Engine Oil
WARNING
Engine oil is very hot and highly pressurized during or
just after operation. Hot oil could blow out of the tank
and can cause serious injury.
NOTICE
Never supply more engine oil than specified level.
Excessive engine oil could cause engine damage.
1. After stopping engine, wait 10 to 20 minutes until
engine oil cools off.
2. Remove drain plug ( A ), open drain valve ( B ), and
discharge engine oil drain. Dispose of used oil
according to local, state and/or federal regulations.
3. When oil is completely drained, close drain valve
and replace drain plug.
4. Remove engine oil filler cap ( C ), and fill engine
with oil. See Checking / Adding Engine Oil in
Operation . (Oil capacity: see Specifications .)
A C B
Change Engine Oil Filter
(For part number, see Replacement Parts)
1. Remove the old filter.
2. Before installing the new oil filter (
D ), spread a thin
layer of oil over the seal ( E ), then install. When the
seal touches the sealing surface, further tighten the
filter by approximately two-thirds turn with a filter
wrench.
3. After the oil filter is installed, check for any oil leaks
during operation.
E
D
Check GFCI Receptacles
WARNING
• Test the GFCI receptacle before each use.
• In case the GFCI has tripped due to the hazard of
ground fault currents, investigate the cause and
correct it.
Regularly check GFCI operation for safety.
1. Unplug all appliances from the generator.
2. Start the engine.
3. Turn each single-phase and three-phase breaker
ON.
Go to
Discount-Equipment.com
to
order your parts