Allmand Maxi-Power MP65-8C1, Operator'S Manual

Page: 21 / 55

20 ALLMAND.COM
2. To reset the button, turn the button head in
the direction of the arrow. If it is not reset, the
machine will not restart.
Air Bleeding
If the unit runs out of fuel, the air must be bled from the
fuel system once the unit is refueled.
1. Turn the manual-auto selector switch on the
control panel to the MANUAL position.
2. Turn the starter switch to the RUN position to
keep the electromagnet pump functioning.
3. Air bleeding will be completed within 20 to 30
seconds.
4. Start the engine.
5. Perform warm-up operation for 3 minutes after the
engine starts.
6. Turn the manual-auto selector switch to the OFF
position.
DPF Regeneration
WARNING Hot Surface and Fire
Hazard.
• During DPF regeneration operation, exhaust gas
of high temperature is discharged. Check and
confirm that there is no person nor flammables
near by. It could cause scalding to person and
fire.
Even during automatic regeneration operation, it
is possible to continue loaded operation.
Passive Regeneration
• Soot collected in the DPF is burnt automatically
because of high temperature during normal
operation under heavy load application.
Active Regeneration
• In operation under light load application or no
load, it turns into active regeneration because
engine exhaust temperature is not high enough to
burn the soot collected in the DPF.
• Even during automatic regeneration operation, it
is possible to continue loaded operation.
Active Regeneration Mode
• ‘Cleaning Exhaust Filter’ lamp ( A ) will turn on.
• The regeneration process will last for about 70
minutes. *
• The lamp will turn off when regeneration is
completed.
* Time required for regeneration depends on load
factor and ambient temperature.
CAUTION Do not stop engine during automatic
regeneration operation, except for unavoidable
conditions.
Active Regeneration
ON
A
Go to
Discount-Equipment.com
to
order your parts