Not for
Reproduction
28 ALLMAND.COM
Clean Oil Separator Strainer
1. Remove pipe (
C
) using a spanner.
2. Remove bushing (
D
).
3. Remove strainer (
E
).
4. Wash strainer in diesel oil and carefully blow out
debris with compressed air. (Be sure to wear safety
goggles.)
5. Install strainer by reversing steps 1 through 3.
C
D
E
Change Air Filter Element
For filter element part number, see
Replacement
Parts
.
1. Loosen latch (
G
), and remove cap (
F
). Clean
interior of cap. Be sure O-ring (
I
) is properly seated
in cap.
2. Dispose of old filter element (
H
), replacing with
new.
3. Clean interior of case (
J
).
4. Install filter element into case, then install cap,
securing with latch.
H
I
J
G
F
Clean / Change Fuel Pre-Filter Element
For filter element part number, see
Replacement
Parts
.
Turn fuel selector valve (
A
) to OFF position.
Loosen drain valve (
B
) and drain out condensed water.
Turn cup (
C
) counterclockwise to remove. Wipe out
split fuel.
Remove float (
D
) inside cup.
Wash element (
E
) and inside of cup with new fuel.
Check element and o-ring, and replace if worn, broken
or damaged.
If air is found in fuel pipe, turn starter switch to RUN
position and loosen air bleeding bolt (
F
) to bleed air.
Tighten after bleeding.
Drain condensate, and dispose according to local,
state and/or federal regulations.
F
A
C
D
B
E
OFF
ON
INSTALL
REMOVE
Summary of Contents for 185 CFM
