Allmand 185 CFM, Operator'S Manual

Page: 6 / 48

Not for
Reproduction
6 ALLMAND.COM
WARNING When refilling separator
receiver tank with compressor oil, stop engine, and make
sure pressure gauge indicates 0 MPa, then gradually
loosen oil filler cap. Residual pressure in separator
receiver tank could cause extremely hot compressed air
and oil to jet out, resulting in death or serious injury.
WARNING Be careful of high-pressurized
blowout.
• After stopping engine, make sure pressure gauge
indicates 0 MPa. Even when the gauge shows 0 MPa,
open service valve to make sure there is no residual
pressure in air piping.
• Residual air under pressure could result in serious
injury.
WARNING Draining separator
receiver tank.
• After stopping engine, confirm pressure gauge indicates
0 MPa and there is no residual pressure, then gradually
open drain valve to drain compressor oil.
• Residual pressure in separator receiver tank could
cause extremely hot compressed air and oil to jet out,
resulting in death or serious injury.
WARNING Adjusting belt tension:
• Attempting to adjust belt tension with machine
running could result in death or serious injury.
• Stop engine, remove starter key, and remove black
negative (-) cable from battery before adjusting belt
tension.
WARNING Hands off cooling fan:
• Contact with cooling fan while machine is running
could result in death or serious injury.
• Stop engine and remove starter key whenever
maintenance is to be performed near cooling fan.
WARNING Wear safety glasses when
cleaning dust accumulated in such devices as air-filter by
blowing compressed air.
WARNING Lighting apparatus:
• If work site is dark, use lighting to illuminate work
area. Working without illumination could result in
death or serious injury.
• Work lighting should be fitted with safety guard to
protect against breakage.
• Do not allow work light to contact fuel or oils, as they
could ignite, causing death or serious injury.
WARNING Opening coolant water drain valve
cap:
• Stop engine and let coolant water sufficiently cool
down before draining.
• If drain valve is opened before coolant water is
cooled enough, hot water could jet out, resulting in
death or serious injury.
CAUTION Refilling or draining engine oil:
• Engine oil is extremely hot during and just after
operation.
• Stop engine and wait 10 to 20 minutes before
checking, adding or draining engine oil.
CAUTION Be sure to perform periodic
check of compressor oil and oil separator. Neglecting
checks could cause overheating oil, resulting in a fire.
CAUTION Treatment of organic wastes.
• Waste liquid from machine contains harmful material.
Do not discharge onto ground or into rivers, lakes or
sea. Such material will contaminate the environment.
• Be sure to use an approved container to hold waste
liquid from machine.
• Be sure to follow local, state or federal regulations
when disposing of oil, fuel, coolant (antifreeze), filter,
battery or other harmful materials.
NOTICE Parts of this machine contain sensitive
electronic components. If welding work is required,
disconnect any electronic equipment on the machine
to prevent damage due to excessive current.
WARNING
• The engine exhaust from this product contains
chemicals known to the State of California to cause
cancer, birth defects, or other reproductive harm.
WARNING
• Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals known
to the State of California to cause cancer, birth
defects, or other reproductive harm. Wash hands
after handling.