Work environment/Safety
When not welding, the drive should
be switched off with the
drive on/off
switch (2)
.
Place the hand extruder with corre-
spondingly set and firmly tightened
handle on a stable, fireproof base as
shown in the illustration.
The hand extruder must not be used in areas where there is danger of explosion or flammable
materials. Ensure a safe posture during work. The power cable and filler rod must be free to move
and must not obstruct the user or third parties during work.
Place hand extruder on a fire resistant base. Hot metal parts and hot streams of air must be kept
at a safe distance from the base and walls.
1. Loosen clamp by turning the
guide handle (6)
anti-clockwise
2. Move the
guide handle (6)
into
the desired operating position
3. Tighten clamp again by turning
guide handle (6)
clockwise
Leister provides a
universal stand
for commissioning and holding the
hand extruder.
Setting the guide handle
Workplace
Ensure the minimum cross-section when using extension cables:
The extension cable must be approved for the site of use (e.g. in
the open air) and marked correspondingly.
When using a power unit for power supply, its nominal power
rating is: 2
×
nominal power rating of the hand extruder.
Length
[m]
Minimum cross-section
(at 230V~)
[mm
2
]
Up to 19
2.5
20 – 50
4.0
Extension cables
1
2
3
6
