Leister WELDPLAST S2 / S2-PVC / S2-TPO
Hand Extruder
Application
Extrusion welding of the following materials:
WELDPLAST S2
PP / PE-HD / PE-LD
WELDPLAST S2-PVC PP / PE-HD / PE-LD / PVC-U
WELDPLAST S2-TPO PP / PE-HD / PE-LD / TPO
Other materials on enquiry
The hand extruder corresponds to the DVS standard 2207–4.
DVS:
Deutscher Verband für Schweisstechnik (German Association for Welding Technology)
Read the operating instructions carefully before starting
the device and keep them for future reference.
Operating Instructions
(Translation of the original operating instructions)
Warning
Hazardous voltage, danger to life
There is a danger to life from electric shock due to electrical voltage. The extruder must therefore only be
connected to sockets and extension cables with a protective earth conductor. Protect the extruder from mois-
ture and wet conditions. Before starting the device, check the power cord, the plug and the extension cable
for electrical and mechanical damage. The extruder may only be opened by instructed, qualified personnel.
Danger of fire and explosion
if the hand extruder is used incorrectly (e.g. overheating of material),
particularly near combustible materials and explosive gases.
Danger – can cause burns!
Do not touch bare metal parts and emerging material while hot. Allow
the device to cool. Do not direct stream of hot air or emerging material towards people or animals.
Caution
The
nominal voltage
indicated on the device must correspond to the mains voltage. If power failure
occurs, the main switch and drive must be switched off (release locking device).
When using the device on building sites, a
residual current circuit breaker
is
essential for the safety
of persons there.
The device must
not be left unattended
when in use. Heat can reach combustible materials which are
out of sight.
The device may only be used by
trained personnel
or under their supervision. Children may not
use the device under any circumstances.
120
230
FI
EN
