52
Patch Release Note
Patch SB251-13 for Software Release 2.5.1
C613-10361-00 REV M
The SHOW DHCP CLIENT command output showed a
ClientId
value even
when the
State
for the client entry was
Unused
. This issue has been resolved.
When the SET IPv6 FILTER command specified a filter that did not exist, an
Operation successful
message was displayed as well as an error
message. This issue has been resolved.
The 16-bit reserved field after the maximum response code field was not set
to zero, as specified by the Internet Draft
“Multicast Listener Discovery
Version 2 (MLDv2) for IPv6”
. This issue has been resolved.
At startup, the switch was not sending or receiving a complete set of
linktrap messages. This issue has been resolved.
The ADD IPV6 FILTER and SET IPV6 FILTER commands accepted a
SESSION parameter when the PROTOCOL parameter was not TCP. The
SESSION parameter specifies the type of TCP packet to match. This issue
has been resolved.
The MIB object
dot1dStpTimeSinceTopologyChange
has been implemented to
record when a topology change is detected by the bridge.
The ETHFORMAT parameter, of the CREATE CLASSIFIER command, was
accepting unsupported values. This issue has been resolved.
The IPv6 priority filter was not working in SwitchBlade and AT-9800 Series
Switches. This issue has been resolved.
The IPv6 neighbour cache was not clearing when the interface was either
disconnected or failed. Now, when an interface either fails or is
disconnected, the neighbour cache is cleared after a short delay.
PCR: 03618
Module: DHCP
Level: 3
PCR: 03619
Module: IPv6
Level: 4
PCR: 03620
Module: IPV6
Level: 3
PCR: 03621
Module: IPG
Level: 3
PCR: 03624
Module: IPV6
Level: 3
PCR: 03625
Module: STP, SWI
Level: 4
PCR: 03626
Module: CLASSIFIER
Level: 3
PCR: 03628
Module: IPV6
Level: 3
PCR: 03633
Module: SWCX
Level: 3
PCR: 03637
Module: IPV6
Level: 1
