28
Patch Release Note
Patch SB251-13 for Software Release 2.5.1
C613-10361-00 REV M
Entering a “?” on the command line, now displays the correct list of
available options.
The RESET IP COUNTER=ALL command was not working correctly when
issued from the command line. This issue has been resolved.
Sometimes the
Agent Address
field in SNMP traps was not the same as the
IP source address. This meant that sometimes the NMS did not send an
alarm to the network manager when traps were received from switches.
This issue has been resolved.
When there were a large number of BGP routes, the SHOW BGP ROUTE
command sometimes caused an error. This issue has been resolved.
The MRU parameter in the SET PPP command was incorrectly handled as
an interface parameter when the configuration script was generated. This
meant that the OVER parameter was omitted. The MRU parameter is now
correctly handled as a link parameter.
Features in SB251-11
Patch SB251-11 includes all issues resolved and enhancements released in
previous patches for Software Release 2.5.1, and the following enhancements:
After loading this software version, please check your alarm relay connections.
Refer to PCR 03209 for more information.
IP is now informed when an Ethernet interface goes up or down, after a 2.5
second delay.
The ADD IPV6 command was not allowing the INTERFACE parameter to
be used when adding a host with link local address. This issue has been
resolved.
A fatal error occurred if the IP module was reset after the ADD IP EGP
command was executed. This issue has been resolved.
The ability to log MAC addresses whenever the ARP cache changes has
been added. To enable this, use the command:
PCR: 03343
Module: UTILITY
Level: 4
PCR: 03345
Module: IPG
Level: 4
PCR: 03346
Module: SNMP
Level: 4
PCR: 03349
Module: BGP
Level: 3
PCR: 03352
Module: PPP
Level: 3
PCR: 02331
Module: IPG, ETH
Level: 2
PCR: 02525
Module: TELNET, PING, IPV6, TCP
Level: 3
PCR: 02571
Module: IP
Level: 3
PCR: 02577
Module: IPG, LOG
Level: 4
