Chapter 3 - Administration
Administration Manual (H.323 Version)
AT-VP504E FXO
40
The VLAN field in the Ethernet file is located after both destination and
source addresses:
0
1
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7
(byte)
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-
| Dest Addr | Src Addr
| VLAN
| Type/Length | ...
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-
The VLAN field is separated as follows:
0
(bit)
1
2
3
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
|
0x8100
| Pri |T|
VID
|
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
For both signaling and media packets, the VLAN priority section is
configurable independently.
Figure 16: 802.1q Configuration Section
The following parameters can be set:
Table 17: 802.1q Parameters
Parameter
Definition
Activate QoS
802.1q
Enables the 802.1q settings.
VLAN ID
VLAN ID located in the VLAN field. You must check
the Enabled option to use the VLAN ID value.
Value: Any number between 1 and 4096.
Default Value: 1
Default Priority for
IP Transmission
Default priority value for IP transmissions located in
the VLAN field.
Value: Any number between 0 and 7.
Default Value: 0
Summary of Contents for AT-VP504E FXS
