Allied Telesis AT-TQ6602, Installation Manual, Page: 59 / 108

TQ6602 Wireless Access Point Installation Guide
59
Attaching the Wireless Access Point to the Wall Mounting Bracket
To attach the wireless access point to the wall mounting bracket on the
wall or ceiling, perform the following procedure:
1. Align the bottom of the access point over the bracket so that the two
screws on the bottom of the device fit into the bracket keyholes. Refer
to Figure 28. (The two screws are installed in “Installing the Mounting
Bracket Screws” on page 55.)
Figure 28. Installing the Wireless Access Point on the Wall Mounting
Bracket
2. Slide the wireless access point until its screws are seated in the
bracket keyhole slots and the bracket thumbscrew is aligned with the
screw hole on the front panel. Refer to Figure 29 on page 60.