AT-S67 and AT-S68 User’s Guide
29
6. From the Create Trunk Menu, type 2 to select Trunk Group. One of the
following prompts will be displayed:
For an AT-FS7016 switch:
Select Trunk Group [1-8] ->
For an AT-FS7024 switch:
Select Trunk Group [1-12] ->
Trunk Group. . .
7. Select your trunk group and press <Enter>.
8. From the Create Trunk Menu, type 3 to select Ports. One of the
following prompts will be displayed:
For an AT-FS7016 switch:
Select Port Number[1-8] ->
For an AT-FS7024 switch:
Select Port Number [1-24] ->
Note
A trunk must have at least two ports designated.
9. Type the number of the ports you wish to trunk and press <Enter>.
You can specify the ports individually (for example 1,2,3) or as a
range (for example 2-4).
10. Type C to select Create Trunk.
11. Type S to select Save Configuration Changes.
12. Configure the ports on the remote switch for port trunking.
13. Connect the cables to the ports of the trunk on the switch.
The port trunk is ready for network operation. To create additional port
trunks, type R twice to return to the Create Trunk Menu then start with
Step 4 on page 28 to repeat this procedure.
