4
Installing the AT-RPS8000 Unit
This section contains the procedure for installing the AT-RPS8000 unit. You
can install the unit on a table or in a standard 19-inch rack. This procedure
does not require that you turn OFF the power to the Ethernet switches to which
you will be connecting the redundant power supply. To install the unit, follow
these steps:
1.
Remove the AT-RPS8000 for the shipping package and store the
packing material in a safe place.
2.
Place the unit on a secure, flat surface with the front facing you.
3.
If you are installing the unit in a rack, perform the following:
a. Remove the snap-on plastic feet from the bottom of the unit, as
shown in Figure 2.
Figure 2 Removing the Rubber Feet
b. Attach the rackmounting brackets to each side of the unit using
the six flathead screws (provided) as shown in Figure 3.
Figure 3 Attaching the Rackmounting Brackets
c. Mount the unit in the rack using standard screws (not provided).
