Allied Telesis AT-2711FX, Installation And User Manual, Page: 68 / 180

Installing the Linux Driver Software
68
Installing the Linux Driver Software
The section describes the following Linux driver installations:
ˆ
“Building a Driver from a TAR File” on page 68
ˆ
“Removing the tg3 Driver” on page 68
Note
On some newer Distributions and Kernels, it may be necessary to
remove the tg3 driver before loading the tg3 driver supplied on the
CD. Follow the instructions in the “Removing the tg3 Driver” on
page 68.
Building a Driver
from a TAR File
To build a driver from a TAR file, perform the following procedure.
1. Create a directory and extract the TAR files:
tar xvzf tg3-<version>.tgz
2. Build the driver tg3.o as a loadable module for the running kernel:
cd tg3- <version> /src
make
3. Test the driver by loading it:
insmod tg3.o
4. Install the driver and man page:
make install
5. To configure network protocol and address, refer to the manuals
supplied with your operating system.
Removing the tg3 Driver
Many various Linux distributions may load the native tg3 driver by default
for the Allied Telesyn Fast Ethernet adapters. It may be necessary to
unload the native tg3 driver first, before installing the tg3.o driver from this
installation.
Note
On some Distributions and Kernels, it may be necessary to remove
the native tg3 driver before loading the Allied Telesyn tg3.o driver.
Even though tg3 is a fully functioning driver, Allied Telesyn recommends