Hardware Reference
71
C613-03031-01 REV E
AR routers support a wide range of interface types, including Ethernet,
asynchronous, synchronous, Basic Rate ISDN and Primary Rate ISDN. Each
interface type (except Ethernet interfaces on the AT-AR026 PIC) can be tested
independently using the Test Facility software. Most tests, however, will also
require the use of a loopback plug. For more information on loopback plugs,
see “
Loopback Plugs for Testing Interfaces
The Test Facility will not test AT-AR026 PICs.
The following examples show how to test specific interfaces.
Test results are displayed with the command:
SHOW TEST
which produces a display like that shown in Figure 33 on page 71.
Figure 33: Example output from the SHOW TEST command.
Board ID Bay Board Name Rev Serial number
----------------------------------------------------------------------------
Base 62 AR720 M1-0 6845181
IC Module 38 0 AR023 PIC Sync M1-1 5917086
IC Module 44 1 AR025 PIC E1 PRI M1-0 6843626
MAC 68 AR011 ECMAC P1-1 6804365
Duration Details
Interface State Result Type (minutes) Data( %OK ) Control
----------------------------------------------------------------------------
eth0 halted * Active LAN trans < 1 BAD ( 0.0) -
TP 0 - - -
ENDEC 0 - - -
MAC 0 - - -
port0 complete good - 1000 good( 99.0) good
port1 complete good - 1000 good( 99.0) good
syn0 testing wait continuous RS-232dte 355 good(100.0) good
dce 355 good(100.0) good
X.21 dte 354 good(100.0) good .
dce 0 - - -
V.35 dte 354 good(100.0) good
dce 0 - - -
PRI0 halted - < 1 BAD ( 0.0) -
mac0 complete good DES 4 good(100.0) -
mac1 complete good STAC 4 good(100.0) -
mac2 complete good ALL 4 good(100.0) -
----------------------------------------------------------------------------
