Hardware Reference
99
C613-03031-01 REV E
Figure 61: Location of PAC slot and pillar mounts on an AR740 base board.
6.
Insert the PAC.
Position the PAC over the PAC slot on the router base card, making sure
that the support pillars located on the router base card are aligned with the
holes provided on the PAC. This ensures that the connector on the PAC is
correctly aligned with the slot on the router base card.
Press the connector firmly into place. Secure the PAC to its three pillars
using the fasteners supplied.
Figure 61 on page 99 shows the PAC slot on an AR740 base board.
7.
Replace the router’s lid and the power cord.
Secure the router’s lid. If you disconnected an RPS supply, reconnect it
now.
8.
If you disconnected interface cables to install the PAC, reconnect them.
The PAC is now ready to test.
740CPU
LED
POWER
NSM BAY
SLIDE-IN BAY 0
SLIDE-IN BAY 1
Clr
Sec
Err
Sys
D
Run
Act
Pwr
LED
LED
LED
LED
LITHIUM BATTERY
DO NOT
DISPOSE IN FIRE
NSM CONNECTOR
LED
RUN
LED
SYSTEM
LED
CLEAR
LED
SECURITY
PORT 0
RJ45
PORT 1
RJ45
LED
LED
LED
BOOT EPROM 1
BOOT EPROM 0
MAC CARD SLOT
PAC SLOT
PAC SLOT
PIC BAY 1
PIC BAY 0
ETHERNET 0
ETHERNET 1
Hot
Swap
Button
Swap
In
Use
LNK/
ACT
100
LNK/
ACT
100
STATUS LEDs
+12V
0V
0V
-12V
+5V
+5V
+12V
0V
0V
0V
-12V
+5V
+5V
THREAD MOUNTS FOR PAC PILLARS
