45-009 REV. 8/20
30
5. Position the attachment on the edge of a pallet. Lower the attachment so that the
lower carriage bar misses the pallet when lowered. Tilt the mast forward to allow the
carriage to disengage from the upper mounting hooks and back away. If lowering
onto a floor, blocks of wood can be placed under the body of the attachment to
raise the rear.
6.
To reinstall, follow the installation procedure in this manual. See Section 4.2.
NOTICE
Equipment damage hazard.
Equipment damage and loss of performance could result
if air is trapped in the hydraulic system.
Activate the hydraulic functions several times after
hydraulic service has been performed, to bleed trapped air
out of the system before returning attachment to service.
6.2 Cylinder Removal
1.
Remove the cylinder rod end cotter pin and clevis pin.
2. Disconnect the hydraulic connections. Cap hoses to prevent contamination, and
tag for reassembly.
3.
Remove cotter pin and clevis pin at the base end of the cylinder.
6.3 Cylinder Disassembly
1.
Remove the cylinder from the attachment. See removal instructions, Section 6.2.
2.
Clamp the cylinder lightly at the base end in a soft jawed vise. Use a block or other
support under the rod end of the cylinder. (Figure 6-3)
Figure 6-3, Cylinder Vise
3.
Spread and remove the retaining ring from the gland cap.
