Allied Systems Allied H6G Series, Service Manual

Page: 19 / 122

Section 1
1 - 11
Motor (See Fig. 1-14)
The hydraulic motor is a dual displacement vane-type
motor for high-performance winches and single-displace-
ment for self-rescue winches. Full or half displacement is
selected at the motor by shifting an integral two position
Figure 1-14 Motor (Two-Spool Shown)
spool. The default position is full displacement when
pressure is not signaled by the winch to the spool. Output
speed is proportional to input fl ow from the pump and
inversely proportional to the motor displacement.
1. Seal Plate Snap Ring
2. Plate Seal
3. Shaft Seal
4. Steel Plate
5. Seal Plate O-Ring
6. Bearing Snap Ring
7. Ball Bearing
8. Shaft
9. Bolt
10. Front Housing, Internal
11. Dowel Pins, Front
12. O-Ring
13. Ball
Checks
14. Screw
15. Two-Speed
Plate
16. Stator
17. Rotor
18. Rotor
Vane
19. Rotor Vane Spring, Outer
20. Rotor Vane Spring, Inner
21. Stator
Vane
22. Stator Vane Spring
23. Dowel Pins, Rear
24. Rear
Housing
25. Needle Bearing