with an empty load). When the burner shuts off, meter should
read 120 Volts and the timer motor should advance the cycle.
7. If voltage is present, but the timer does not advance, replace
timer.
8. If meter does not read voltage, check the wiring continuity us-
ing ohm scale on meter. UNPLUG dryer. Remove Red/Black
striped wire from terminal “T” on timer and perform an ohms
check between the timer wire and the cycling thermostat ter-
minal, where the Red/Black stripe wire attaches on the cy-
cling thermostat (located on the blower assembly). If the wire
shows continuity, reattach the wire on terminal “T” of timer.
Replace cycling thermostat and check for proper operation.
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
11
Part No. D515517ENR3
Summary of Contents for ZDE3SRGS173CW01
Page 2: ......
