10
802643
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Troubleshooting
3. No Spin Due to Out-of-Balance
Switch Wiring Problem Starting
Serial Nos. Beginning 0307
A “no spin” condition could be the result of an
open circuit in the wire harness or out-of-balance
switch.
a. Check that the harness is still connected to the
out-of-balance switch. The out-of-balance
switch is a
normally closed switch
.
b. To test the electrical circuit, disconnect
electrical power to the washer.
c. Remove the “H1” connector from the inverter
control assembly.
d. Use an Ohm meter to check the black/white to
violet/white wires. Circuit should read closed.
An open reading indicates a bad switch or
wire harness problem.
e. Flex the harness at the plastic wire clamp and
test continuity. If the base wire harness has an
open circuit it MUST be replaced or the
broken wires must be repaired with UL
approved terminals.
f. After replacing or repairing the wire harness,
secure the harness wires to the original
factory locations. Refer to
Figure 1
.
(1) The plastic wire clamp should be angled
toward the switch at 45 degrees.
(2) The clamp should wrap around the first
section of tape on the harness.
(3) The harness should be secured to the
inverter control shield with a wire tie.
(4) The tie should wrap around the third
section of tape on the harness. Refer to
Figure 1
.
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect all electric power to the machine and accessories before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start machine with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded.
• Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
Figure 1
45 degrees
Wire Clamp
First Section
of Tape
Wire Tie
Third Section
of Tape
FLW1842B
Summary of Contents for CTSA7AWN
Page 2: ......
