8
3
4
9
5
6
7
2
1
CHM2645N_SVG1
1.
Cold Water Valve Inlet
2.
Hot Water Valve Inlet
3.
Rubber Washer (plain)
4.
Red Fill Hose (hot)
5.
Hose Coupling
6.
Hot Water Supply Faucet
7.
Cold Water Supply Faucet
8.
Filter Screen (screen must be facing outward, toward water
supply)
9.
Blue Fill Hose (cold)
Figure 29
Connect Inlet Hoses with Y-Connectors (60-100
Models)
To connect water service (for laundries with two [2] supply fau-
cets) to a machine with hoses, use the following procedure:
1. Before installing hoses, flush the building’s water system at
the machine connection valves for at least two (2) minutes.
2. Remove the four (4) plain rubber washers and four (4) filter
screens from the accessories bag supplied with the machine.
3. Install one (1) plain rubber washer onto one end and one (1)
filter screen into the other end of each fill hose. The screens
must be facing outward toward the water supply. Refer to
.
4. Screw one (1) of the Y-connectors (supplied with the ma-
chine) into the cold water supply faucet and one (1) into the
hot water supply faucet.
5. Screw hose couplings with the filter screens onto the water
supply faucets until they are finger-tight. Use the two (2) red
color-coded hose for the hot water connection and the two (2)
blue color-coded hose for the cold water connection.
6. Using pliers, screw approximately 1/4 turn.
7. Screw the coupling with the plain rubber washer of one (1) of
the red color-coded hoses (attached to the hot water connec-
tion) onto the main fill valve inlet (marked with a red label).
Screw the coupling with the plain rubber washer of the other
red color-coded hose onto the tub fill valve inlet (marked with
a red label). Tighten to finger-tight. Refer to
.
8. Screw the coupling with the plain rubber washer of one (1) of
the blue color-coded hoses (attached to the cold water connec-
tion) onto the main fill valve inlet (marked with a blue label).
Screw the coupling with the plain rubber washer of the other
blue color-coded hose onto the tub fill valve inlet (marked
with a blue label). Tighten to finger-tight. Refer to
.
9. Using pliers, screw approximately 1/4 turn.
IMPORTANT: DO NOT cross thread or overtighten
couplings. This will cause them to leak.
10. Hang hoses in a large loop; do not allow them to kink.
11. Turn on water supply and check for leaks.
12. If leaks are found, turn off the water, unscrew hoses and rein-
stall them until there are no leaks.
IMPORTANT: Turn off water supply whenever there
will be an extended period of non-use.
If additional hose lengths are needed or using hoses other than
those supplied by manufacturer, flexible hoses with screen filters
are required.
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
67
Part No. F8619501ENR11
Summary of Contents for BCA Series
Page 2: ......
