F016J13758-A ISSUE 28-01-22 SE
7
CHANGING A UC LAWN CARE CARTRIDGE
To remove a cartridge:
1. Remove the grass bag and battery
2. Pivot the two cartridge clamps (C1) upwards away from the machine
3. Press the release lever on the cartridge securing lever (B1), then pivot it towards the rear of the machine
until the latch pin locates in upper slot.
4. Pull the cartridge unit out using the handle (D1)
To insert a cartridge:
1. Make sure the cartridge clamps are pivoted upwards (C1) and cartridge securing lever (B1) is pivoted
towards the rear of the machine
2. Hold the cartridge unit by the handle and slide it into the mower. There are a pair of guides either side of
the chassis to help locate it correctly
3. Pivot the cartridge clamps (C1) downwards towards the machine
4. Press the release lever on the cartridge securing lever (B1) then pivot towards the front of the machine
until the latch pin locates in lower slot. This is tensioning the belt so needs to be done quite firmly
USING THE MOWER WITH A UC LAWN CARE CARTRIDGE
S
ee “Setting the Height of Cut” in the mower instructions, then adjust the machine to achieve the required level of
aggressiveness and to suit the ground conditions.
Height settings range table:
Cartridge
Height of cut range
Recommended setting
SUREBLADE™ 6-BLADE
CYLINDER / REEL
5 mm to 50 mm
25 mm
SUREBLADE™ 10-BLADE
CYLINDER / REEL
4 mm to 20 mm
< 20 mm
UC SCARIFIER
0 mm to -10 mm
0 mm to -6 mm
UC VERTICUT
0 mm to -10 mm
0 mm
UC AERATOR
0 mm to -14 mm
-14 mm
UC LAWN BRUSH
0 mm to 10 mm
0 mm
UC DETHATCHER
0 mm to -14 mm
-6 mm to -8 mm
