- 3 -
ELECTRIC STOVE INSTALLATION
Plugging in the heater
NOTE:
1. This heater is for use on 120 Volts.
2. A 15AMP circuit is required to operate this appliance. If the breaker trips when the appliance is running, you
may need to move the appliance to another location or unplug other appliances that are on the same circuit
3. ADAPTERS ARE NOT ALLOWED CANADA
NOTE
: A 15AMP,120 Volts circuit is required. Dedicated circuit is preferred but not essential in all cases, a
dedicated circuit will be required if, after installation, the circuit breaker trips or the fuse blows on a regular basis
when the heater is operating. Additional appliance on the same circuit may exceed the current rating of the circuit
break.
WARNING
:
1. Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure that the
power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire, electric shock or injury
to persons.
2. Construction and electrical outlet wiring must comply with local building codes and other applicable
regulations to reduce the risk of fire, electric shock and injury to persons.
3. Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric shock or injury to
persons, always use a licensed electrician.
BEFORE USING THIS APPLIANCE:
1. Please check the circuit break for this appliance on?
2. Light bulbs may become loose during shipping, if the flame effect is dim or does not operate properly at first,
ensure that the light bulbs are properly secured in the sockets(bulbs should be finger tight, don’t over tighter)
see “Replacing Light Bulb” section of this manual for instructions.
3. The information regarding this appliance can be found on the rating plate located on the back of the unit
PLUGGING IN THE HEATER:
1. Make sure the appliance main “
I
/O”
is switch OFF(refer to operating instruction section)
2. Plug the unit into a no less 15Amp/120V outlet.
