- 4 -
OPERATING INSTRUCTIONS
NOTE:
1. When you first turn the heater on, it may emit a slight but harmless odor. This odor results from certain oils or
greases being heated as the appliance is used for the first time. This odor is perfectly safe and will stop shortly,
it will not reoccur after the first operation of the appliance.
Control Panel
Using the Control Panel:
Master Power Switch(A)
Open the cover and push button A down (1) to “on” position.(see FIG A)
FLAME EFFECT
Push
“O/I”
(On/Off) button (B) or
“O/I”
(On/Off) button (M) on the remote control to begin flame effect. The red
power light “ ” and dimmer light “ ” will automatically come on. The flame effect can be adjusted by pressing
the dimmer “ ” button (C) or dimmer “ ” button (L) on the remote control. When pressed, the red light will
blink and the flame effect will cycle from high to low. Press the dimmer “ “ button (C) or dimmer “ “ button (L)
on the remote control again to lock in desired flame brightness. The red light “ “ will remain on. This brightness
will be kept until the dimmer “ ” button (C) or dimmer “ ” button (L) on the remote control is pressed again.
HEAT SETTING
1. Turning on Master Power Switch (A) and
“O/I”
(On/Off) button (B) or
“O/I”
button (M) on the remote control
2. Press
“650W”
button (D) or
“650W”
button (K) on the remote control to active the low heater setting. The
red light above will indicate that the heater is functioning on low.
3. Press
“650W”
button (D) or
“650W”
button (K) on the remote control again to shut off the heater.
4. Press
“1300W”
button (E) or
“1300W”
button (J) on the remote control to active the high heater setting.
The red lights above
“650W”
and
“1300W”
buttons will indicate that the heater is functioning on high.
5. Press
“1300W”
button (E) or
“1300W”
button (J) on the remote control again to shut off the heater.
Note
When the heater begins to work, it will give off cool air for about 10 seconds before the heating function is
activated
