
053016
Page 7
SECTION 1
INTRODUCTION
Section 1
The Safety Alert Symbol identifies important safety messages written
on the paver decals, as well as, in this manual . When you see this
symbol, be alert to possible danger that could result in serious injury
or death .
Note the use of key signal words in association with the
Safety Alert Symbol:
DANGER
- An immediate and specific hazard which will
result in severe personal injury or death if the proper precautions are
not taken .
WARNING
- A specific hazard or unsafe practice which
could result in severe personal injury or death if proper
precautions are not taken .
CAUTION
- Unsafe practices which could result in personal
injury if proper precautions are not taken and as a
reminder of good safety practices .
YOU
are responsible for the safe operation and maintenance of your
Allen Paver . You must ensure that you and anyone else who is going to
operate, maintain or work around the machine be familiar with the op-
erating and maintenance procedures and all related safety information
contained in this manual .
GENERAL SAFETY PRECAUTIONS
1 . Always read and fully understand theOperator’s Manual and the
Safety Decals on the machine before trying to operate or service
this equipment .
2 . It is wise to have a first aid kit available and to be familiar with
its contents .
3 .
Keep a “charged” fire extinguisher within reach whenever you
work in an area where fire may occur . Also, be sure you have
the correct type of extinguisher for your situation:
Type A: Wood, paper, textile and rubbish.
Type B: Flammable liquids .
Type C: Electrical equipment .
4 . Be sure to wear safe work clothing . It should be well fitted and
in good repair . Do not wear rings, wrist watches or loose fit-
ting clothing when working on machinery, they could catch on
moving parts causing serious injury . Wear sturdy, rough soled
work shoes, safety glasses and any other protective gear that is
warranted by the work environment .
Introduction
5 . Keep work area organized and clean . Wipe up oil spills of any
kind . Keep tools and parts off floor . Eliminate the possibility of a
fall which could result in serious injury .
6 . Be sure to reinstall safety devices, guards or shields after ad-
justing and/or servicing the machine .
7 . After servicing, be sure that all tools, parts or servicing equip-
ment are removed from the vehicle or engine .
8. Do not get into a rush!
Use recommended hand holds and
steps with at least three points of support when getting on and
off the paver . Keep steps, floors, hand holds and controls clean
and free of grease . Face the machine when climbing up and
down and never jump off the paver or dismount while it is in
motion .
9 . Keep all personnel clear of augers, rollers and carriage frame
when operating the paver .
10 . Do not permit riders on the paver .
HYDRAULIC SYSTEMS PRECAUTIONS
1 . Make sure that all components are in good working condition .
Replace any worn, cut, abraded, flattened or crimped hoses and
metal lines .
2 . Do not attempt makeshift repairs using tape, clamps or ce-
ments. The hydraulic system operates under extremely high
pressure and such repairs could cause serious injury .
3 . Wear proper hand and eye protection when searching for a high
pressure leak . Use a piece of wood or cardboard as a back stop
instead of hands to isolate and identify leaks .
4 . If injured by concentrated high pressure steam or hydraulic
fluid, seek medical attention imedi ately . Serious infections or
toxic reaction can develop from hydraulic fluid penetrating the
skin .
REFUELING PRECAUTIONS
1 . When refueling, keep the hose nozzle or the funnel and con-
tainer in contact with the metal of the fuel tank to avoid the
possibility of an electrical spark igniting the fuel .
2 . Do not overfill the fuel tank - overflow creates a fire hazard .
3 . DO NOT SMOKE when refueling and never refuel when engine
is running .
4 . Prevent fires by keeping the machine clean of debris, grease
and spilled fuel .