iLive Reference Guide – Hardware
Part 1 - 42
AP6526-1 iss.5
iLive-R72 rack ear fitting instructions
Refit 5x M4 x 8mm screws
12U
13U
M6 x 16mm SLOT screw
part AB0344
M6 cup washer
part AB0345
Remove 8x M4 x 8mm TORX screws
Use T20 driver
M4 x 8mm TORX screw
part AB0332
563mm (22.2") to rear of pod
from front of rack rail
533.4mm (21") 12U rail
578mm (22.75") 13U rail
217mm (8.54")
131mm (5.16")
230mm (9.06")
193mm (7.6")
47.5mm (1.87")
from front of rack rail
470mm (18.5")
485.5mm (19.1")
513mm (20.2")
540.5mm (21,3")
52.5mm (2.07")
120.7mm (4.75")
237mm (9.33")
172mm (6.77")
482.2mm (19")
from front of trim
368mm (14.5")
540mm (21.26")
To fit rack ears
Store remaining screws
471.4mm (18.56") with side trims fitted
36.8mm (1.45")
1mm to end of 12U rail
190.6mm (7.5")
C
133.3mm (5.25")
133.3mm (5.25")
482mm (19") with rack ears fitted
Rack Mounted
Desk Top
5mm to end of rail
33mm (1.3")
Rack Ears - Flush Mounted
Rack Ears - Angled
16 degrees
Desk Top - Side Trims Fitted
1
2
3
2
3
Dimensions
The
iLive-R72
Surface can be configured for
desk top, flight case, 19” rack or furniture
installation. The plastic side trims can be
removed and replaced with the metal rack
ears provided. A minimum 12U rack space is
needed. More may be needed depending on
connector access requirements.
Two rack ear positions are available – either
flush with the control panel or angled at 16
degrees for a lower profile fit.
When rack mounting ensure adequate
ventilation and space for the connectors,
cables and lamp fitting at the rear.
Note
– Due to the height of the TouchScreen
a rack case with a deep lid is required. Many
standard off-the-shelf equipment cases are not
intended for consoles such as the iLive.
However, most flight case manufacturers can
provide custom cases to suit different mixer
models.
One suitable design is the
Gator
G-Tour-
SLMX12 12U slant top road case shown
above. For further information refer to
www.gatorcases.com