3 Mounting the terminal
© 2022 Interflex Datensysteme GmbH | IF-4735 Time Recording Terminal | 04.22
9
3.2 Fastening the back panel of the housing
Installation site
Please observe the following recommendations:
n
Permitted ambient conditions for the device
n
Minimum distance of 10 cm between the connecting cables and the nearest power cable
n
Installation height 1200 mm
Minimum distances between RFID and BLE devices
If several RFID devices are mounted too close together, mutual interference may occur.
Thus, the following minimum distances must be maintained:
The minimum distance for back-to-back installation depends on the nature of the wall in
between.
Please note that all BLE devices within range are recognized and that the respective doors
open too (according to the permission) when the "auto-booking" function is enabled.
The cables for the connection of the terminal can be surface or flush-mounted. If the cables are
surface-mounted, a spacer (accessory) facilitates the installation.
NOTICE
Damage due to improper installation of the terminal
Improper installation of the back panel and the terminal may result in damage to the terminal.
u
Do not make any changes to the back panel.
u
Attach the back panel to a smooth and even surface.
u
Use only the original screws and do not use any washers.
The Installation of an AT housing is described in a separate chapter (see below).
