Alkin W3 Series, Instruction Manual & Parts List

Page: 40 / 83

W 3 S E R I E S
H I G H P R E S S U R E A I R C O M P R E S S O R
©ALKIN COMPRESSORS
35
The purifier housing as well is made of stainless steel and it contains in it a refillable cartridge. Follow the
refilling instruction that is supplied with the refilling kits for this procedure. The procedure to remove and
replace a purifier cartridge is as follows:
1.
Loosen the nuts (4) that is located in the center of
the top cover.
2.
Install the adapter tool (3) which is supplied with
the compressor, onto the cover (5), using the two
bolts (2), that come with the adapter.
3. Use a ratchet tool (1) to loosen the cover (5).
Turn the cover four turns and then remove the
two bolts (2) and the adapter tool (3) from the
cover.
4. Put the two bolts (2) in place to turn the cover (5)
by hand. Turn the cover (5) and remove the whole
assembly from the purifier chamber.
5. Pull the cartridge (7) out of the purifier
chamber(8).
6. Open the flat end of the cartridge; remove its
contents. Clean the inside of the cartridge by
rinsing, adn throughly drying. by rinsing, adn
throughly drying.
7.
Use the instrcutions supplied with the cartridge
refilling kit to refill the cartridge. Always replace
the chemicals, felt pads and the o-rings with new
materials and parts.
8. Inspect and clean –if necessary- the inside of the
purifier chamber.
9. Insert the cartridge back into the purifier chamber.
Do not drop. Make sure the cartridge sits in place
properly.
10. Inspect –and replace if necessary- the o ring and /
or the backing ring on the seal housing.
11. Insert the whole cover in to the purifier chamber.
Install the mountny adapter (3) in place, using the
same bolts (2). Tighten the cover until it is flat with
the purifier chamber top surface.
4
5
6
2
3
5
6
8
1
2
3
5
6
8
5
8
8
7