18
BASIC OPERATIONS
Delete channel
1.In Standby state, after pressing
key, the top left corner of LCD displays " ", then press
, the
channel number twinkling means getting into store/delete channel mode.
2.Turn selector knob to select the channel which you want to delete.
3.Press
key, and hold
key for 2 seconds, the frequency disappear with in two "beep" sounds,
the channel has been deleted.
Programming scan
Setup the frequency of L1 channel, U1 channel, L2 channel and U2 channel will realize VFO frequency
scanning border limited. L1 & L2 is starting frequency, U1 & U2 is end frequency. When VFO frequency
between L1~ U1 or L2 ~ U2, transceiver will scan frequencies between L1 ~ U1 or L2 ~ U2. When VFO
frequency is lower than L1 or L2, transceiver will scan frequencies higher than L1 or L2. When VFO
frequency is lower than U1 or U2, transceiver will scan frequencies higher than U1 or U2.
1. In VFO mode, enter desired frequency and relative setup, press
key, the top left corner of LCD
displays “ ” icon, then press
key switch into channel mode, channel number flashes
2. Rotate channel switch to choose desired channel number.(L1, U1, L2, U2)
3. Press
key, and then hold
for 2 seconds, after two "beep" sounds, this channel has been
stored.
NOTE: To make this setup, L1 and U1 must in same frequency band, L1 must lower than U1. L2 and U2
must in same frequency band, L2 must lower than U2.
