Alimak Scando 650 DOL, Technical Description

Page: 135 / 148

ALIMAK 34733 - 1/01
Preparations before installation
To install your rack and pinion hoist as efficiently and safely as
possible and at lowest cost, it is important that the following
preparations are made before the erector is called and the
installation is started.
Permission
Make sure the chosen site of erection meets the requirements set
out by local authorities for safety and inspection and that their
permission, if necessary, to install the hoist has been obtained.
Erection place
Prepare the installation site so that electric power, light, lifting
equipment and tools are available and there is adequate access
for the lift transporter – beware of overhead obstructions.
If possible, prepare for the installation of ties and landing
accessories such as supports, platforms and railing. Suitable
places for attaching the ties are vaults, balconies or other
concrete or steel structures. See applicable installation drawing.
Remember that these structures must be strong enough to absorb
the reaction forces of the ties and landing door assemblies.
All mast sections should be stored on dry firm ground and as
close to the erection place as possible.
Foundation
Prepare the foundation with parts required for fixing the base
frame of the mast. See chapter ”Foundation” in the manual
Technical Description.
IMPORTANT!
Make sure before casting the foundation that the measurement
between the foundation frame and the face of the hoistway
corresponds to the ties to be used.
Delivery check-up
Check the delivery against shipping lists and look for transpor-
tation damage.
Should there be any damage, report the same to the responsible
transportation insurance company within 7 days from the date
of arrival of the goods.
Other claims should be made to ALIMAK representative within
the same period.
I
1
STOP
Transportation
damage?
Shortages?
i 1
i 2
i 3