31
ALI-TP7112RH PTZ Outdoor Camera User Manual
SECTION 4: CONFIGURING THE PTZ CAMERA
SYSTEM SETTINGS page 1
SYSTEM SETTINGS page 2
SYSTEM SETTINGS page 3
To change a parameter value:
2.
Use the
p
and
q
buttons to move the position icon to the parameter you want to change, and then click
Iris+
. The
position icon will change to a .
NOTE
: If the position icon is before SYSTEM TIME or DISPLAY SETTINGS, a submenu will
open. See "4.6.1 Setting SYSTEM TIME" on page 32.
3.
Use the
p
and
q
buttons to show the parameter to what you prefer.
4.
Click
Iris+
again to change the parameter. The position icon will change to either a , or
.
5.
Repeat steps
1
through
3
above to change other parameters, if needed. See the list below.
Parameters include three pages:
Page 1:
•
SET SOFT ADDR
: If the
SET SOFT ADDR
is set ON, the soft address is the valid address for connecting the camera. The
SOFT
ADDRESS
ranges from 1 to 255. If the
SET SOFT ADDR
is set as OFF, the hard address set by the DIP switch is the valid address
of the camera.
•
SOFT BAUDRATE
: You can select either 2400, 4800, 9600 or 19200. If the
SET SOFT BAUD
is set to OFF, the baud rate is set
by the hardware DIP switches.
