SHUT DOWN - EVERY NIGHT
•
Turn Cycle Selector to 0 and turn off the power from the wall.
•
Remove Scrap Trays (1) and Upstand (3) to drain the Wash Tank.
•
Once the Wash Tank is fully drained remove and rinse Wash Pump Filter (2) before
replacing back into the machine along with the Upstand (3) and Scrap Trays (1).
CLEANING – AT LEAST ONCE A WEEK
Remove, rinse and replace when machine has cooled down:
Scrap Trays
1
Wash Pump Filters
2
Drain Upstand
3
Wash & Rinse Arms
4
Thumb Screws
5
Inspect and clear all jets in the upper and lower
Wash/Rinse Arms using a small object such as a
toothpick where necessary to remove any
blockages prior to rinsing.
SUGGESTED BEST PRACTICE
Pre-rinse
Scrape and/or rinse trays, plates & glasses in cool water.
Chemical
Use a good quality non foaming commercial detergent and drying agent – do
not use domestic detergents which will cause the wash tank to foam.
7/31/2019
Starline XP-3 Operator Manual
9
Operator Use Guide
START
•
Turn on at wall.
•
Ensure the Upstand (3) and Wash Pump Filter (2) are
firmly in place.
•
Check the Scrap Trays (1) are in place and shut door.
•
Turn the Selector Switch to any Cycle (I, II or III).
•
Power light glows red and machine fills automatically.
•
Once full, rinse heating starts.
OPERATION
•
Select required Cycle of I (1 minutes) , II (2 minutes) or
III (3 minutes).
•
Load items into the machine and shut door.
•
Press Start Button to start machine.
•
Start Button glows green while machine operates.
•
When Start Button goes out, the cycle is complete.
NOTE: The machine may be started while the rinse water
is being heated – the machine will continue to run the
wash cycle until the rinse water is up to temperature.
Wash Temp Gauge
Cycle Light
Selector Switch
Rinse Temp Gauge
Power On Light
