Algas SDI Direct Fired 120/60H, Operation & Maintenance Manual

Page: 53 / 56

807
31 3/4"
A
A
CAPACITY CONTROL
VALVE
LIQUID
INLET
VALVE
PILOT
BURNER
HEAT EXCHANGER
928
36 9/16"
744
29 5/16"
504
19
7 8
"
440
17
5 16
"
3/4" FNPT LIQUID INLET
B
PRESSURE
RELIEF VALVE
DRIP LEG DRAIN VALVE
THERMOSTAT AND REIGNITOR ASSEMBLY
1" MNPT VAPOR OUTLET
BURNER
REGULATOR
START/SHUTDOWN INSTRUCTIONS
ISOLATION
VALVE
664
26
1 8
"
305 12"
SECTION A-A
4 X 1/2"
[13mm]
MOUNTING HOLES
DETAIL B SCALE 1 : 4
2ND STAGE VENT (3/4" FNPT)
10.
1ST STAGE VENT (1/8" FNPT)
9.
NOTES:
ALL DIMENSIONS ARE IN INCHES [mm].
1.
VAPORIZER PRESSURE VESSEL RATED AT 290 PSIG [20 BAR] MAWP.
2.
VAPORIZER RELIEF VALVE SETTING 250 PSIG [17.2 BAR].
3.
cULus APPROVED.
4.
CE MARKED (PED).
5.
VAPORIZER CAPACITY AT 0
F AND 100 PSIG PROPANE INLET CONDITION
6. 80 GPH [160 KG/HR].
VAPORIZER TO BE SECURED THROUGH THE FOUR MOUNTING HOLES ON
7. ABOVE GROUND, LEVEL, SOLID, NON-COMBUSTIBLE BASE.
HEAT INPUT 102,720 BTU/HR [108,370 KJ/HR].
8.
USE THE 1/8" FNPT PORT TO PIPE AWAY 1ST STAGE VENT IF REQUIRED.
9.
USE THE 3/4" FNPT PORT TO PIPE AWAY 2ND STAGE VENT IF REQUIRED.
10.
APPROXIMATE SHIPPING WEIGHT 207 LBS [94 KG].
11.
FRONT VIEW
DOOR REMOVED
FOR CLARITY
LEFT VIEW
RIGHT VIEW
ISOMETRIC VIEW
NO SCALE
151 S. Michigan St., Seattle, Washington. USA 98108
Tel: (206) 789-5410 Fax: (206) 789-5414
Drawn By: Checked By: Approved By: Date: Scale: Job #
Part #
Title:
Dwg. #
Size:
Sht. No.:
Rev.:
TOLERANCES
UNLESS OTHERWISE
SPECIFIED
B
DO NOT SCALE DRAWING
RWP
A.S.D.I. STD.
1of
1
1504-6001
D
5/23/12
1:12 AND NOTED
INTERPRET THIS DRAWING IN ACCORDANCE
WITH ANSI/ASME Y14.5-2009
DN
THIS DRAWING SHALL NOT BE REPRODUCED OR
USED IN ANY MANNER DETRIMENTAL TO IT'S
INTERESTS. ALL RIGHTS RESERVED.
© COPYRIGHT ALGAS-SDI
.X
.XX .XXX
ANGLE
0
30'
FRACTIONS
1/4"
THIRD ANGLE PROJECTION
SMALL DF VAPORIZER 80/40 EQUIPMENT DRAWING