5
GAS SUPPLY INSTALLATIONS:
Because of the
Alfresco
™ Pizza Oven’s unique design, it is possible to install the gas supply (NG
or LP) from a place below the unti in addition to the standard back supply location.
The oven is constructed with an opening at the bottom heat shield to facilitate connections from below.
(See figure # 8)
Standard connections through the back panel can be con-
verted to bottom connections as follows:
•
Removing the 3/8” (LP) or 1/2” (NG) Brass compression
fitting on the back,
•
Rotating down the 90° 1/2” elbow immediately behind
the back panel,
•
Re-installing the appropriate size compression fitting for
a flexible hose connections, or…
•
Hard-piping the oven with 1/2” NPT piping.
When designing a built in enclosure with gas supplies connected from the bottom of the unit, a shut-off
valve with unrestricted access is required.
Always shut off the gas supply when the unit is not in use to ensure safety.
For additional ALF-PZA-BIA product dimensions which might aid in the construction of your built-in en-
closure, please refer to the ALF-PZA-
BIA Specification Sheet found in our website;
www.alfrescogrills.com
Figure # 8
(2) 90° 1/2” ELBOWS
CONVERTIBLE
PRESSURE
REGULATOR
ELECTRICAL
CORD
3/8” OR 1/2”
COMPRESSION
FITTING
TURN DOWN
ELBOW
CONNECTION
OPENING
BOTTOM HEAT
SHIELD
