www.alfrescoheaters.ie
8
Mounting distances for
model
ALF 25,50
2.
Attach the stainless steel mounting brackets to the ceiling/wall using the appropriate fasteners (not
supplied).
3.
Loosen and then remove the thick bracket bolts from either end of the heater.
There are two washers supplied with each bracket bolt. Keep them together with the bolts after
you have removed them.
4.
Thread a bracket bolt through the hole in one of the mounting brackets.
5.
Ensure that the washers are on the bracket bolt in the following order:
a.
Lock washer (notched washer)
b.
Standard washer (flat washer)
The bracket should be inside both washers, with the standard washer closest to the heater. You can
refer to the following picture to see this illustrated.
Replacing the bracket
bolt washers
Once you tighten the bracket bolts after mounting the heater, the lock washer allows the angle of
the heater to be adjusted without loosening the bracket bolt.
6.
Position the heater between the mounting brackets.
7.
Thread the bracket bolt into one end of the heater.
8.
Tighten the bracket bolt securely to lock the heater into the mounting.
9.
Repeat this process with the other end of the heater, ensuring that the weight of the heater is
supported until both bracket bolts are secured.
10.
Rotate the heater to the desired angle to point towards the heating area.
3.4.
Installing the Element
The quartz heating elements are fragile. It is recommended that you mount the heater before installing the
element. This helps to minimise any possible damage to the element that could occur during installation.
Lock washer
Bracket bolt
Mounting bracket
Standard washer
16.0cm
99.5cm between mounting hole centres
