Alfa Laval IsoMix External Drive, Instruction Manual

Page: 13 / 50

4 Installation
All position numbers and item numbers refer to the drawings shown and specified in chapter 8.1 IMXD without middle
section and 8.2 IMXD with middle section.
Step 5
1. Position the assembly of the DN125 valve body w. flange (25) and stub flange w. DN125 flange (23) so that the DN125 flange
on the stub flange (23) is upwards.
2. Lift the assembly of the DN125 valve body w. flange (25) and stub flange w. DN125 flange (23) up, so the downpipe of the
spray section (16), that sticks out of the swing cone, is inserted through the DN125 valve body (25).
3. Slide the assembly of the DN125 valve body w. flange (25) and the stub flange w. DN125 flange (23) up to the counter
flange attached to the swing cone.
4. Attach the flange of the to the counter flange using 8xM10x40 screws and matching nuts (not part of the machine – AL item
no.: 9612499303).
NOTE
Ensure that the side port of the DN 125 valve body is oriented in the right direction (fine adjustment can be made by loosening
the clamp (24) enough to be able to turn the DN125 valve body (25)).
1
)
1
)
4306-0013
IMPORTANT
If a middle section has to be installed, follow step 6 and 7 for middle section drive shaft (57) and middle section downpipe (56)
installation (where middle section downpipe acts as the valve section in Step 6). And then continue with step 6 and onwards for
attaching the valve section to the now-attached middle section.
1) Swing cone with flange
2) Spray section with nozzles
13