Alfa Laval ALTB-SB-20, Instruction Manual

Page: 9 / 74

3 Installation
The instruction manual is part of delivery. Study the instructions carefully.
The Agitator is for permanent fastening.
Make sure the motor corresponds to the environment.
Check the direction of rotation before operation.
Step 1
3.3.2
See illustration in 7.5.1 page 38.
A. The three “Adjustable Leg For Bottom Console” pos. 70 are fastened to the “Bottom Console for Agitator” pos. 74 using
the three “Screw” pos. 77.
B. The assembled “Bottom Console” from a)
“Guide spindle for bearing” pos. 69
“Tool – Bushing” pos. 83,
“Tool – Back stop” pos. 85,
“Screw” pos. 91,
“Propeller” pos. 73,
“Agitator Shaft” pos. 71 (if delivered),
“Propeller” pos. 72 (if delivered),
“Agitator Shaft” pos. 75,
are lowered into the tank and assembled. In some cases all the parts can be assembled outside the tank and lowered into
the tank assembled. All threads must be greased to ensure not to damage the threads.
C. According to the order specific drawing "Agitator with Tank" that comes with the manual (not in the manual) the correct
Agitator position is selected (0/125/175 mm off center) which specify which position of holes to be used (data in this
manual are not to be used – find order specific drawing).
Example of an order specific drawing "Order specific "Tank With Agitator" drawing, example" are to be found in 8.2, page 42.
D. Mount the “Tool Guide Plate” pos. 80 on the “Tank mounting flange” pos. 99 letting the shaft pos. 75 entering the correct
hole in pos. 80. The “Tool Guide Plate” must be fastened to the tank top using two diagonally located holes in the tank top.
E. Mount the “Tool – Top Guide” pos. 82 to the “Tool Guide Plate” pos. 80 using the four “Screw” pos. 88.
F. Mount the “Tool – Top Guide” pos. 81 into the “Tool – Top Guide” pos. 82.
G. Rotate / orientate pos. 82 enabling the “Screw” pos. 90 to be used to fasten the shaft in vertical direction during adjustment
of the “Bottom Console” pos. 74.
9