-3-
ALFA IN a.s ©
www.alfain.eu
3
1.
INTRODUCTION
Congratulations on your new ALFA IN product. We are proud to have you as
our customer and will strive to provide you with the best service and reliability
in the industry.
This Operating Manual has been designed to instruct you on the correct use
and operation of your ALFA IN product. Your satisfaction with this product and
its safe operation is our ultimate concern. Therefore please take the time to
read the entire manual, especially the Safety Precautions. They will help you to
avoid potential hazards that may exist when working with this product.
Read and understand this entire Manual and your employer’s safety practices
before installing, operating, or servicing the equipment. While the information
contained in this Manual represents the Manufacturer's best judgement, the
Manufacturer assumes no liability for its use.
Machine PEGAS 40 PLASMA PFC is designed for cutting metal on the basis of
modern technology cutting material through a thin beam plasma gas.
PEGAS 40 PLASMA PFC is equipped by Power Factor Correction (PFC),
which allows operation on single phase voltage networks
110 V – 230 V.
PEGAS 40 PLASMA PFC is designed for high-quality cutting of materials up to
20 mm thick carbon steel (for more information, see instructions
below). Productive cutting of carbon steel can be to a thickness of 12 mm.
At lower demands on the quality of the cut can be cut through (separate) the
material thickness to 25 mm.