A Tour of the MultiMix FireWire
2
17
2TK TO CTRL ROOM Switch
When you engage this switch, the signal coming in from the 2-
TRACK jacks is routed to the headphones and to the control
room output. This level is controlled by the HDPH / CTRL
ROOM level control and cancels out any signal from the main mix.
AUX RETURN A LEVEL
This is the level control for the signal returning to the mixer via
AUX RETURN A.
EFFECTS / AUX RET B LEVEL
If you are using one of the MultiMix 8 FireWire’s internal effects,
this knob controls the effect level. If AUX SEND B is connected
to an external device, this knob controls the level for AUX
RETURN B.
LED Meters
These are the two rows of yellow, green and red lights you see in
the master section of the mixer. The LED meters allow you to
view the signal level of the main mix and 2-TRACK IN depending
on which signal you have routed to the control room mix.
POWER Indicator
When this LED is lit up, that means the POWER ON switch on
the rear of the mixer has been activated.
+48V Indicator
When this one is lit up, that means the PHANTOM ON switch on
the rear of the mixer has been activated and is sup48V
phantom power to all XLR mic inputs.
Summary of Contents for MultiMix8FireWire
