0
N. SYSTEM’S STATUS CHECK
(For two-way transceiver operation only)
When you want to check the system’s present status through the LCD
screen, Press the transceiver
F
button twice, within seconds press
(C)
button. It responds with one melody sound, the LCD screen should
be illuminated.
O. DRIVER PAGING
(For two-way transceiver operation only)
It is useful the event that someone wants to page the driver of the parked
vehicle. Under the ignition switch “off” condition, press and hold the valet
switch for seconds to page the driver, one chirp sound shall be emitted
from the vehicle and the paging melody sound continues you Remote LCD
transceiver and “
” indication flashes on the LCD screen.
P. DOME LIGHT CONVENIENCE DELAY & SUPERVISION
Upon disarming, the interior lights will remain on for 0 seconds. Note: Turn ON the ignition
switch or arm the alarm will turn off the dome light.
Q. IGNITION CONTROL POWER DOOR LOCK/UNLOCK
If the vehicles door locks have been interfaced to the system, the system will automatically lock
the vehicle’s doors when the ignition is turned “ON” and/or unlock the vehicle’s doors when the
ignition is turned “OFF”.
R. TRUNK RELEASE (CHANNEL 3) OUTPUT
Press and hold the
button on transmitter for two seconds to
remote control the trunk release or other electric devices.
S. CHANNEL 4 TIMER CONTROL OUTPUT
Press the transmitter (4) and the (4) buttons at the same time to ac-
tive Channel 4 function. Channel 4 is user-programmable timer output. You
may program the built-in timer to send a ground signal for any time interval
between second and minutes. For instance, this timer output may be
used to turn on the headlight, power window or sunroof. (Factory defaults
setting at momentary output.)
T. CHANNEL 5 TIMER CONTROL OUTPUT
Press the transmitter (5) and (5) buttons at the same time to active
Channel 5 function. Channel 5 is user-programmable timer output. You may
program the built-in timer to send a ground signal for any time duration
from second to 0 seconds. For instance, this timer output may be used to
turn on the headlight, power window or sunroof. (Factory defaults setting at
momentary output.)
U. CHANNEL 6 TIMER CONTROL OUTPUT
Press the transmitter
✱
(6) and
(6) buttons at the same time to active
Channel 6 function. Channel 6 is user-programmable timer output. You may
program the built-in timer to send a ground signal for any time duration
from second to 0 seconds. For instance, this timer output may be used to
turn on the headlight, power window or sunroof. (Factory defaults setting at
momentary output.)
rEmOTE STArT OpErATION
A. TO REMOTE START THE VEHICLE:
. When you want to start your vehicle,
. Press
✱
button twice on the transmitter
. The parking light will activate to indicate the remote start received the signal. (A melody
sounding from your Remote LCD transceiver and “
” icon will flashes on the LCD screen to
confirm the remote start was activated.)
4. The engine will start approximately 5 seconds.
