8
9
tem is now disarmed. The vehicle doors will unlock and dome light will turn on for 0 seconds
upon disarming when interfaced with the security system.
System disarm pAThWAY ILLUmINATION
This feature turns the parking light “ON” for 0
seconds upon a unlock signal and for 0 seconds upon the lock signal.
TWO STEp dOOr UNLOCk:
This feature will independently unlock the drives
door only when disarming the security system. Pushing the button on the
transmitter a second time within seconds will unlock the entire vehicle.
AUTOmATIC rE-Arm
(See Feature
“I - 2”
Programming): If this feature
is selected, the security system will automatically re-arm itself 60 seconds after disarming with
remote transmitter. Automatic rearm will cancel if any door is opened before the 60 seconds timer
has elapsed.
J. DISARMING WITHOUT A TRANSMITTER
The Override function may be used if the remote transmitter is lost or inoperative.
. Enter the vehicle and turn the ignition switch to ‘ON’ position. (Alarm will sound.)
. Within 0 seconds push and release the valet switch
The alarm will stop sounding and enter the disarm mode. You can now start and operate the
vehicle normally.
K. VALET MODE: (System in Disarm or Valet mode)
The valet switch allows you to temporarily bypass all alarm function, eliminating the need to
hand your transmitter to parking attendants or garage mechanics. When the system is in valet
mode, all alarm function is bypassed, however the remote panic feature and remote door locks
will remain operational. To use the valet mode, the system must first be disarmed either by using
you remote transmitter, or by operating the Manual override sequence.
Enter Valet mode:
. From the disarmed condition, turn the ignition to “ON”
position.
. Push and hold valet switch for seconds until the
LED turns on. The LED wills remain on as long as the
system is in ‘valet mode’.
Exit Valet mode:
. Return to normal operation, turn ignition ‘on’.
. Push and hold valet switch for seconds, The LED will turn off indicating the system is exiting
the valet mode.
rEmOTE VALET:
(System in Disarm or Valet mode)
Press and release
button on the transmitter three times within seconds to enter / exit valet
mode. A parking flash to confirm enters valet mode and two parking lights flashing to confirm exit
valet mode.
L. CAR LOCATOR
Press the button to activate the car locator function. The siren will
chirp 6 times. The parking light will flash times, for you to easily locate
your car.
M. PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger
the alarm in case emergency.
. Press and hold the button for second. The alarm will immediately
sound.
. During panic mode, the normal function of this transmitter button will
be suspended. The and buttons can be used to lock and unlock
the doors (if the option is installed), however once the button is
pressed, the vehicle’s starter disable device, (where installed) will be
disabled allowing the vehicle to start.
. To stop the alarm, press and hold the or button on the transmitter again for seconds.
Also if any transmitter button other than or button is pressed and released, the panic
mode will be turned off immediately.
4. If the button is not pressed, the alarm will automatically stop after 0 seconds.
remote door
Lock
remote door
Unlock
